![]() You should now see the pad is a horrible black lump of mush. Now move the head away from park - again being gentle. Once located, leave the pad for 5 or 10 minutes whilst the solvent does its trick. What we are trying to do is bring the solvent dampened pad into contact with the print head. Be careful no to force it or you may break something. The pump cap will try to raise up to meet the bottom of the print head as you move it back. Manually move the print head GENTLY back to its park position. Put the solvent onto the tissue making it quite damp, but not totally soaked. If you have any ammoniated window cleaner like Windex you can use this. The solvent I use is JR Ink Jet Cartridge flush as seen on ebay and the like. Now take a syringe or similar and put some solvent into it. Now lay this pad over the top of the pump cap and fold the left edge down toward the base of the machine as in image one (the tissue is the yellow bit in the image) Now take a piece of kitchen paper and fold it over a couple times to make a pad approx 3"x1". It will be a black looking spongy pad covered in ink. Look to the right where the head carriage is normally parked and you should see the pump cap area. ![]() With the top of the machine open, you should be able to move the print head carriage by hand. Switch on the machine and when the head has moved away from its park position, remove the power lead. The first thing we need to do is get the head away from its parking position. ![]() You can do a manual cleaning using some kitchen paper and a little solvent and a small plastic bag. SOURCE: problem with print outs from printer
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |